Page 1 of 1

Glass

Posted: Wed Aug 06, 2008 11:06 am
by George Brockie
Is there any particular glass resin that is better for putting the kneeler on the new body for my rigg ?. & remember your talking to someone that knows nothing about glass .

Resin selection

Posted: Sun Aug 10, 2008 4:50 pm
by Rick
George,
The 4:1 stuff that is normally used for Kevlar and Carbon Fiber is easier to mix and doesn't small as bad as the normal stuff they sell. Also a little stronger, I think.
Rick

fairing shit....

Posted: Sun Aug 10, 2008 9:28 pm
by sidecarzang
George, George, George.
Yr fairing is made out of glass and epoxy resin. I think Pierre supplied some of that with yr stuff which is at ? Brian's I think. I will talk to Pierre and ask him how to measure. I think it's ... something to one. It would be better to stay with the same material.
See ya soon....
Jean-Guy

Posted: Mon Aug 11, 2008 4:37 pm
by Bobby F
George,

I believe you can only put Duct tape to Duct tape, but you might want to rub down the paint on it first. 8) 8) 8) 8)


(that was a joke George)

Bobby ox

glass

Posted: Thu Sep 11, 2008 11:14 pm
by George Brockie
Bobby .
Have you been told today ?

Posted: Fri Sep 12, 2008 4:00 pm
by Frank Riolo
Resin and hardener from Home Depot, DO NOT USE FINISHING RESIN !!! It leaves a waxy layer on top.
Use a heat gun if temp is below 70 degrees F