Glass

Got a technical question, need info, ask the experts
Post Reply
George Brockie
Posts: 369
Joined: Thu May 18, 2006 6:56 pm

Glass

Post by George Brockie » Wed Aug 06, 2008 11:06 am

Is there any particular glass resin that is better for putting the kneeler on the new body for my rigg ?. & remember your talking to someone that knows nothing about glass .
George Brockie aka Oatmeal Savage

Rick
Superside Board
Posts: 56
Joined: Sat Dec 04, 2004 5:22 am
Contact:

Resin selection

Post by Rick » Sun Aug 10, 2008 4:50 pm

George,
The 4:1 stuff that is normally used for Kevlar and Carbon Fiber is easier to mix and doesn't small as bad as the normal stuff they sell. Also a little stronger, I think.
Rick

sidecarzang
Posts: 354
Joined: Sat Dec 04, 2004 1:57 pm
Contact:

fairing shit....

Post by sidecarzang » Sun Aug 10, 2008 9:28 pm

George, George, George.
Yr fairing is made out of glass and epoxy resin. I think Pierre supplied some of that with yr stuff which is at ? Brian's I think. I will talk to Pierre and ask him how to measure. I think it's ... something to one. It would be better to stay with the same material.
See ya soon....
Jean-Guy

Bobby F
Posts: 938
Joined: Wed Jun 06, 2007 2:27 am

Post by Bobby F » Mon Aug 11, 2008 4:37 pm

George,

I believe you can only put Duct tape to Duct tape, but you might want to rub down the paint on it first. 8) 8) 8) 8)


(that was a joke George)

Bobby ox
Double Trouble - and remember - Happiness is a three wheel drift! :D :D

George Brockie
Posts: 369
Joined: Thu May 18, 2006 6:56 pm

glass

Post by George Brockie » Thu Sep 11, 2008 11:14 pm

Bobby .
Have you been told today ?
George Brockie aka Oatmeal Savage

User avatar
Frank Riolo
Posts: 123
Joined: Mon Dec 06, 2004 5:25 am
Contact:

Post by Frank Riolo » Fri Sep 12, 2008 4:00 pm

Resin and hardener from Home Depot, DO NOT USE FINISHING RESIN !!! It leaves a waxy layer on top.
Use a heat gun if temp is below 70 degrees F

Post Reply